ALTAWINGMAN
Joined: 13 Sep 2006
Posts: 4
|
| Posted: Sun Feb 18, 2007 11:46 pm Post subject: TIPS & HINTS |
|
|
| HI GUY'S ALTAWINGMAN HERE WITH KIT #120 IN CALGARY ALBERTA CANADA THIS FORM IS GETTING LOTS OF INTREST I AM ENJOYING THE TIPS AND HINTS THERE GREAT' I JUST THOUGHT I WOULD LEAVE SOME THINGS I HAVE HAD GOOD LUCK WITH MIXING HYSOL PLASTIC SPOONS TO MEASURE AND POPSICLE STICKS LARGE SURINGE WITH SMALL TUBE MAKES NICE FILLETS . PUTTING IN I BEAM AFTER LIGHTLY SANDING WITH SCOTCHBRITE PAD THROW IN SNOW BANK TO COOL I BEAM DOWN 'HEAT WINGSPAR WITH HEATGUN PUT LITTLE WD40 ON COLD I BEAM PUSH RIGHT IN NO PROBLEM. FLAPS / AL FIBERGLASS LEADING EDGE FIND THE SMALL PLYWOOD FILLER PIECES THE ONE'S THAT GO BETWEEN THE LE RIBS USE ONE FOR A TEMPLATE DRAW A LINE BETWEEN THE TWO HIGH SPOTS ON BOTH SIDES THEN PUSH IN THE FIBERGLASS AT EACH END TO MARK WHERE TO TRIM THE FIBERGLASS STRIP . TO LINE UP PULLEYS ; BEND A PIECE OF PIANO WIRE AROUND THE PULLEY THEN USE IT FOR A ALIGNMENT TOOL.. A MUST TOOL IS 1/4 INCH 90DEG AIR DIE GRINDER WITH 2 INCH ROLOK DISKS 80 GRIT AND 60 . THANKS FOR NOW HAPPY BUILDING ; ALTAWINGMAN CALGARY ALBERTA |
|
