| View previous topic :: View next topic |
| Author |
Message |
Dave Krall CFII SEL SES
Joined: 14 Mar 2007
Posts: 303
Location: Seattle WA
|
| Posted: Wed May 02, 2007 2:54 pm Post subject: Push rod to control mixer bellcrank |
|
|
It looks like the push rod has to be FLEXED upward under constant pressure, a few inches to make the connection to the contol mixer bellcrank.
This actually looks like no problem but, I'm wondering if it is considered the normal assembly?
Thanks again. |
|
| Back to top |
|
scubarider
Joined: 24 Dec 2006
Posts: 287
Location: Cleveland, GA
|
| Posted: Wed May 02, 2007 3:56 pm Post subject: should not be |
|
|
My rods seem to be straight and no tension. Here is a pic of the center.
Dennis |
|
| Back to top |
|
Dave Krall CFII SEL SES
Joined: 14 Mar 2007
Posts: 303
Location: Seattle WA
|
| Posted: Wed May 02, 2007 6:28 pm Post subject: |
|
|
| Thanks! But I'm talking about the forward end under the cockpit where the long pushrod connects to the control stick mixer bellcrank... |
|
| Back to top |
|
KevinC
Joined: 18 Aug 2005
Posts: 191
Location: Prosser, Washington
|
| Posted: Wed May 02, 2007 8:37 pm Post subject: push rod |
|
|
Mine had to be bent slightly upward at that end, then it worked fine.
Kevin |
|
| Back to top |
|
| |
