Page 1 of 1

Individual design and production of wooden propellers

PostPosted: Thu Dec 22, 2016 3:30 pm
by meglin
This propeller went to the United States.
The propeller is covered with fiberglass and clear varnish.
All the holes are formed.
Diameter - 1727 mm.
The propeller is individually designed to provide high performance RV-9 aircraft.

Re: Individual design and production of wooden propellers

PostPosted: Fri Mar 10, 2017 5:34 am
by meglin
We continue to design and produce propellers for individual orders.

Re: Individual design and production of wooden propellers

PostPosted: Sat Apr 01, 2017 5:41 am
by meglin
Propeller for Limbach

Re: Individual design and production of wooden propellers

PostPosted: Wed Feb 07, 2018 4:27 am
by meglin
"At long last I have flown my new aeroplane with your prop. It was only the first flight yesterday and for just 30 mins. My first impression is that the prop is very good match for both the 0320 and my airframe. The climb rate was up to 1500ft/min and level cruise at 2200/2300 revs nearly 120 Kts after only a very rough short evaluation. I think the 75% cruise will be 130kts so the prop must be very near to the best compromise available.
As you know many Vans 6 owners use the popular 0320 lycoming and the Vans is very similar in general configuration (but not construction) to my airframe so this spec prop should work well. As the Vans is very popular there should be a good market for your product."