Page 1 of 1

Got the Engine Mounted

PostPosted: Sat Oct 27, 2007 7:13 pm
by scubarider
Got the engine mounted today.  That was difficult.  Things did not line up right putting in the four bolts to engine.  The motor mount lords/bolts were directly in the way.  The two rear cooling hoses were also directly in the way so much so had to remove them and go to town for longer ones to route further out.  Did finally get everything on though.  Now just trying to figure where everything else goes.  The dang oil tank is a [email protected]#$%.  Pretty big for such a small location. :?
Any pictures of a completed 912S would be much appreciated  :wink:
Dennis

engine mounting pix

PostPosted: Sat Oct 27, 2007 8:21 pm
by KevinC
Dennis,

Here are a few pix of an Escapade from LaGrande, OR that I took at Arlington.  Hopefully they will help.

If you can, post (or send) some pix of the 'problem spots'.  Thanks

K
Image

Image

Image

Image

thanks

PostPosted: Sun Oct 28, 2007 6:59 pm
by scubarider
Thanks Kevin,  Thanks to your pictures you sent I positioned the cooler overflow bottle on the other side that I was planning to.  
:D
Dennis