Page 1 of 1

Fabric tape problems

PostPosted: Wed Nov 07, 2007 1:24 pm
by Roger
Has anyone had any problem with sanding to deep over a tube and not being able to get the divot out? I got a little too aggresive on sanding the primer, and created a, what I'd call a trench along the length of the tube, and haven't been able to either fill it with primer, nor get it sanded out. I'm wondering if there's a way to get it out. I tried masking both sides of the problem and re-spraying and then sanding the masked area, but that didn't work. Any ideas out there?
Roger

hmmm

PostPosted: Thu Nov 08, 2007 1:59 pm
by scubarider
For something like that I would have done the same by covering the surrounding areas with tape.  Reshoot sand, reshoot sand and one more time.  It should fill in.  I would not use filler.  You will have to hit it enough so that you can sand DOWN to the outside areas covered.
Sorry I can not be more help.
Dennis