Door and Window fit

For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.

Moderator: scubarider2

Door and Window fit

Postby b1x4nqb » Sun Mar 09, 2008 6:01 pm

While pre-fitting my doors I noticed my Pilot side door to window does not fit properly.  The part where both door and window bend to go around my left elbow do not bend at the same point.  I'm attaching a shot.  Did you guys experience this also.  I noticed the left door also does not sit flush with the outside (out about an inch) unlike the passenger side which is perfect.  It may be the jig at the factory or just poor welder alignment, not sure which.  Anybody else?  I tried bending it but it is too stiff and I don't have the proper bender to do the job.  Wondering if I should call the factory to see what they can do??

Paul, PA
Attachments
Door Above.JPG
Door Above.JPG (1.7 MiB) Viewed 1106 times
b1x4nqb
Veteran Member
 
Posts: 282
Joined: Mon Aug 14, 2006 11:53 am
Location: Orwigsburg, PA

door to window

Postby scubarider2 » Sun Mar 09, 2008 7:39 pm

The door to frame and window to door HAS to fit perfect.  This is the only way the lexan will fit correctly.  Mine both fit properly.  Recheck how the hinges with pins fit at the top.  Could be that is what is out of line.  Either way I would call JA and ask Troy.
Dennis
User avatar
scubarider2
Topic Moderator
 
Posts: 1065
Joined: Mon Jan 28, 2008 7:03 pm
Location: Cleveland, GA


Return to Just Aircraft