We're trying to figure a good easy way to stabilize the trim tab cable as it passes under the horizontal stab. Must it be connected to that surface somehow? And some additional attachment to give it enough slack to allow full up elevator of 30 degrees?
Thanks in advance.
trim tab cable attachments on horizontal elevator?
-
- Veteran Member
- Posts: 922
- Joined: Wed Mar 14, 2007 11:29 pm
- Location: Seattle WA
-
- Veteran Member
- Posts: 922
- Joined: Wed Mar 14, 2007 11:29 pm
- Location: Seattle WA
- Gary H
- Veteran Member
- Posts: 257
- Joined: Fri Sep 29, 2006 1:18 am
- Location: Othello, WA
cable
I put a clamp there ( took the rubber off) and used another cable clamp to hold the cable. Hope I said this right. I'll see you at Arlington and I'can show you .
You do not have the required permissions to view the files attached to this post.
Will fly for food!!
-
- Veteran Member
- Posts: 922
- Joined: Wed Mar 14, 2007 11:29 pm
- Location: Seattle WA
Re: cable
Looks good, thanks for the explanation. See you at Arlington.Gary H wrote:And, as you can see, I welded a steel plate to balance the elevator