I have my wing tips cut out out and the nav/strobe light bases mounted etc. I see that the little triagular pieces that fit alongside the ailerons, is a couple of inches too short and also at the top end of said same, there is still a gap. Has anyone done anything other then use the factory supplied pieces?
Roger
Wing tips
- Gary H
- Veteran Member
- Posts: 257
- Joined: Fri Sep 29, 2006 1:18 am
- Location: Othello, WA
wing tips
Mine fit pretty good. I put a different leading edge on so had to do a little work to get it to fit. Hope the photo's help you.
Gary
Gary
You do not have the required permissions to view the files attached to this post.
Will fly for food!!
- scubarider2
- Topic Moderator
- Posts: 1086
- Joined: Mon Jan 28, 2008 7:03 pm
- Location: Cleveland, GA
- KevinC
- Veteran Member
- Posts: 447
- Joined: Fri Aug 19, 2005 12:42 am
- Location: Prosser, Washington
Mine short too
FWIW -
Mine were short too. I made a small aluminum piece to bridge the gap (since I am afraid of fiberglass work) and glued/riveted it into place.
Kevin
Mine were short too. I made a small aluminum piece to bridge the gap (since I am afraid of fiberglass work) and glued/riveted it into place.
Kevin