I've measured my stainless wire and it comes out to .050 dia.jesander wrote:Something else to check. While installing the new .060 dia. trim control cable, I found that the cable terminal nut or bug nut or whatever it's called, can be secured with the set screws in a way that locks the cable to the arm. This will cause the cable to bend/flex and fatigue as the arm travels through its arc. This condition is easy to spot at the elevator end but can be overlooked at the trim lever down between the seats.
Joe S.
I'm thinking it may be thick enough because stainless steel seems harder to bend.
I don't think .060 wire would go into the housing either, it's so tight.
Haven't decided for sure what to do.