Page 7 of 7

Re: For Sale and Accessories and Upgrades

PostPosted: Thu Jan 25, 2018 8:52 pm
by jblackmon
I sent you my number via pm. Tks

Re: For Sale and Accessories and Upgrades

PostPosted: Sat Feb 03, 2018 12:35 pm
by Jack L
Cleaning out the hangar

Rotax 912 oil lines with Aeroquip hoses and fittings, built and tested in an aviation hose shop. Used for less than 200 hours. Just aircraft price $400.00, asking $150.00

IMG_4361.JPG


Synchromate TS101, purchased new, never used. Aircraft Spruce over $250.00 with accessories, asking $150.00

IMG_4364.JPG


Matco wheel assemblies, never used. Spare wheel bearing. Rims available at Matco for $110.00 each, complete set with rims sells for $630, asking $250.00

IMG_4362.JPG


Custom built Aluminum internal door frame stops. These allow you to seal the door inside of the aircraft chromoly frame. This will work on both the Highlander and Super STOL.

IMG_4365.JPG

IMG_4366.JPG


Send PM or call
six 0ne 3 6 three nine 30 five three

Jack

Re: For Sale and Accessories and Upgrades

PostPosted: Fri Feb 16, 2018 1:11 pm
by marl59
I have a used Rotax 912 ULS firewall forward complete with Highlander bed mount, voltage regulator, oil cooler, oil tank and hoses, radiator, starter switch, solenoid, exhaust etc. Pretty much everything you will need to mount and run the engine. It ran great when I removed it. I'm converting to Yamaha RX1 power so don't need it. If your looking to get a build flying for cheap this would work very well. I'll crate it and ship it to you for shipping cost. I also have a very nice Catto 80" prop and spinner for sale. Pics to follow. The only negative is that this 2005 model engine has a 1600 hour TBO and it has about 1,730 hours on it. It comes with recently rebuilt carbs, a carb balancer, the upgraded fuel pump. It ran perfectly when I removed. I'd like to get $6,000 for the engine and accessories and $2,600 for the prop and spinner. Its a STOL prop and usually got the plane off the ground in under 100'. I have the 29" Airstreaks on the plane so 80 MPH is the normal cruise with this setup. PM me if your interested. Thanks-Love this forum!