Would any of you builders have pictures of the control you fabricated for the locking tail wheel.
Not sure where to install or how to make.
Thanks! Oren
locking tail wheel
- SheepdogRD
- Proprietor
- Posts: 930
- Joined: Tue Nov 30, 2010 5:41 pm
- Location: West of Atlanta, GA
Re: locking tail wheel
I just looked at one at the factory. They used a clone of the manual trim mechanism, mounted on the other side of the flap handle.
Richard Holtz
Highlander N570L -- Ms. Tonka -- in gestation
If just enough is really good, then too much ought to be perfect.
Highlander N570L -- Ms. Tonka -- in gestation
If just enough is really good, then too much ought to be perfect.
-
- Forum Regular
- Posts: 40
- Joined: Tue Nov 20, 2012 5:11 pm
- Location: Fuquay Varina, NC
Re: locking tail wheel
I do not have a fuel valve so I installed two levers side by side on the triangle plate one for the parking brake and one for the tailwheel with both levers down or forward for takeoff. In addition I added a 12 volt plug at the bottom of the triangle.
Wayne
Wayne
-
- Veteran Member
- Posts: 254
- Joined: Sat Dec 15, 2012 3:50 pm
Re: locking tail wheel
I put in a Ray Allen electric servo for pitch trim so Adam used the pitch trim lever for mine. Hope that helps
Cheers,
John
Cheers,
John