Page 1 of 1

Spar attach fittings

PostPosted: Thu Aug 28, 2014 8:41 pm
by taildragger7
I had a chance to speak with Troy the last time I was down there about these. I am having to have another set made. I should have bought a set from Troy but I have already committed to the guy that is making them. The last set were made from .040" molly steel. Is this thick enough as a hangar flying has left some doubt as to the strength of such thin material. Is there anyone willing to measure the thickness of one so I can get the correct thickness? I would appreciate it as I can't get in touch with the factory via e-mail. My MTOW is 1050.....less than the much wanted Highlander. Got to finish this one and sell it so I can buy a kit.