Flickering Alternator Fail Light

For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.

Moderator: scubarider2

Flickering Alternator Fail Light

Postby ja30driver » Tue Nov 22, 2016 10:09 pm

I have a 912ULS with a bolt on alternator.... the 'alt fail' light is flickering at all rpm... but... it is stillmregitering 14.1 volts on my G3X.... bad diod? Thoughts? Should I be overly concerned so long as the Voltage shows 14.1V?
ja30driver
Forum Regular
 
Posts: 26
Joined: Fri Jan 15, 2016 10:46 pm

Re: Flickering Alternator Fail Light

Postby Jack L » Wed Nov 23, 2016 7:22 am

I didn't connect the lamp and am happy monitoring my Dynon. I would trust the G3X indication.

I am not an expert but this is what I would do:

Check the connections from pin C to L at the regulator, the lamp circuit goes from C to the light bulb and back to L where it will find a ground in the regulator. Also ensure the regulator's case has a good ground. If you cannot find a loose connection or faulty wiring remove the connector at the regulator and clean the contacts. Once the wiring and light bulb are eliminated, if the fault persists, it is likely the electronic switch within the regulator. On the diagram below imagine the light bulb positioned externally between pins C and L, power comes from C through the light and back to L, if the regulator output falls below a certain threshold a ground is made internally to light the lamp.

This is the way I understand it, I hope this helps.

large_regulator_2006.png
Jack L
Veteran Member
 
Posts: 104
Joined: Sun Apr 27, 2014 12:10 pm


Return to Just Aircraft