Page 2 of 2

Re: One piece Lexan Door

PostPosted: Thu May 11, 2017 11:20 am
by FredHoffman
Just finished the doors with one piece of lexan. I made a cut at the back of the door so it would contour to the frame. The cut goes from the high point on the center support to the rear. It would be possible to overlap the pieces but I cut it so they were butted next to each other then added a trim piece to hold them down securely. It might be possible to have a smaller cut but I don't think it would follow the frame and would stand off a bit.

Re: One piece Lexan Door

PostPosted: Fri May 12, 2017 10:23 am
by gkremers
Fred,
Really nice job. When it comes time to change out the Lexan This looks like a good option.

Gary

Re: One piece Lexan Door

PostPosted: Fri May 12, 2017 10:35 am
by Tralika
Fred,
Thanks for posting the photos of your door mod. It's a nice solution to the overlapping plex.

Re: One piece Lexan Door

PostPosted: Fri May 12, 2017 12:31 pm
by FredHoffman
version 2.0. I thought the trim piece was too big.