Page 2 of 2

Re: Lap belt attach points

PostPosted: Sat Aug 26, 2017 11:45 am
by Tralika
They make rubber and plastic nut caps that should work. Here's one example from McMaster https://www.mcmaster.com/#bolt-caps/=193ydi0 If you do a google search for rubber hex nut caps you'll see a bunch more. Plastic might be better than rubber, less friction against the fabric. A little dab of of adhesive on the end of the bolt should keep it from rubbing off.

Re: Lap belt attach points

PostPosted: Sun Aug 27, 2017 7:38 pm
by SuperFly
Great thinking John! Thanks for the tip. Ill order, and report back with my findings.

Re: Lap belt attach points

PostPosted: Tue Aug 29, 2017 10:18 am
by AV8R Paul
Ahh someone that understands the Engineering load capacity behind the cable design. I doubt the aluminum tube that has been compromised with multiple holes drilled in would be anywhere close to adequate. I like your non-gender specific 200# person. Your analysis proves it will hold a 210# old guy that looks like Santa Claus. :lol:


danerazz wrote:Thanks, I thought it may have been crow.

As for the cable sizes, if you think about it, a 200# non-gender specific person at 9g is 1800lbs of force. Each half of the seatbelt carries half of that, or 900lbs. A cable loop has two ends, dividing the force at each end in half, 450lbs per eye, but the middle of the loop will bear closer to the 900lb because it is a single piece, not two separate cables at a given attach point. A 7x19 SS cable has 1760lb rating, galv is 2000lb. 3/32 7x7 is 920 lbs, so even it would be adequate. 1/8" cable is WELL suited and easy to work with. I am pretty sure the control cables are 3/32 as well, at least on my standard highlander.