Page 1 of 1

Pulley and Electric Trim Servo Covers

PostPosted: Wed Feb 07, 2018 11:58 am
by Jack L
Hello All,

Not sure what builders are using for pulley and servo covers but if anyone is interested in purchasing my moulds PM me.

Pulley
IMG_1621.JPG

IMG_4373.JPG

IMG_4374.JPG


Servo
IMG_1151.JPG

IMG_4375.JPG

IMG_4376.JPG




Jack

Re: Pulley and Electric Trim Servo Covers

PostPosted: Thu Feb 08, 2018 12:16 am
by BDA
Maybe someone that will sell them?

I need some but dont do glass

Chris W??
Factory?

Re: Pulley and Electric Trim Servo Covers

PostPosted: Sun Feb 11, 2018 10:46 am
by Jack L
The PM function doesn't seem to be working all the time.

If interested contact me at [email protected]

Re: Pulley and Electric Trim Servo Covers

PostPosted: Mon Feb 12, 2018 11:48 pm
by AV8R Paul
I have purchased the molds, I will have some carbon fiber left from my flying tail. I intend building 2 sets, once I get the molds. I intend giving Chris Wallen a set to install on my SuperSTOL.

Re: Pulley and Electric Trim Servo Covers

PostPosted: Tue Feb 13, 2018 4:41 am
by z987k
I've noticed most highlanders don't have anything covering the pulleys. Are you seeing a cruise speed increase with these?

Re: Pulley and Electric Trim Servo Covers

PostPosted: Tue Feb 13, 2018 11:01 am
by Tralika
I made fairings for the aileron and flap pulleys as well as the top aileron and rudder cables. I doubt the fairings will make a measurable difference in the drag on my Highlander. I think they will help keep the pulleys clean and dry and prevent water from entering through the cable openings in the upper wings and fuselage. And I like the way they look. I made mine from fiberglass using a foam mold. It was pretty easy using the technique in this EAA video.

http://www.eaavideo.org/detail/videos/c ... rue&page=1

Re: Pulley and Electric Trim Servo Covers

PostPosted: Tue Feb 13, 2018 12:36 pm
by BucF16
Has Anyone come up with a file for a 3D printer. I know there was some discussion on it a few months back.

Bruce