It looks like the push rod has to be FLEXED upward under constant pressure, a few inches to make the connection to the contol mixer bellcrank.
This actually looks like no problem but, I'm wondering if it is considered the normal assembly?
Thanks again.
Push rod to control mixer bellcrank
-
- Veteran Member
- Posts: 922
- Joined: Wed Mar 14, 2007 11:29 pm
- Location: Seattle WA
-
- Veteran Member
- Posts: 287
- Joined: Sun Dec 24, 2006 10:06 am
- Location: Cleveland, GA
should not be
My rods seem to be straight and no tension. Here is a pic of the center.
Dennis
Dennis
You do not have the required permissions to view the files attached to this post.
Living life on the edge makes me dizzy. I love Dizzy!
-
- Veteran Member
- Posts: 922
- Joined: Wed Mar 14, 2007 11:29 pm
- Location: Seattle WA