Page 1 of 1

I need a picture please!!

PostPosted: Tue Aug 21, 2007 8:44 pm
by Uwe Jens
How are you guys?
My Highlander kit finally arrived to Ecuador!!  I have some parts missing, but the people in Walhalla have being great and are helping me with all the parts that didn´t arrive.  
After doing all the inventory check; one of the parts missing are the jury struts, I´ve been looking thru the lift struts and I don´t see any support for the jury struts, do any of you guys have a picture on how they are attached, this is to see if there is anything else missing?
I hope to start my building adventure this coming week.  Thanking you in advance for all the help you could provide, since in my country no one has a clue on this kind of kit.  I am the first person in Ecuador in buying a Highlander.  
Thanks again and good luck,
Uwe/. :D

Jury struts - does this help?

PostPosted: Wed Aug 22, 2007 9:08 am
by KevinC
Should attach to a couple of tabs on to be attached to the spars and clamps that go around the lift struts.



PostPosted: Wed Aug 22, 2007 9:32 am
by Uwe Jens
Thank you very much Kevin,  apparently I am missing the 4 clamps too.  I need to take a picture on 4 pieces that I have no clue what they are,  they are not on the packing list neither have a code number.  I will be bothering you again, to find out if you know what they are.
Thanks again,

PostPosted: Wed Aug 22, 2007 10:23 am
by Uwe Jens
Hi Kevin,this is the picture , what is this ?

Unidentified Parts

PostPosted: Wed Aug 22, 2007 6:39 pm
by Wes
Those look like the "Rudder - Adjustable Link" P/N JAPCF0780.0 that were also supplied with my kit. I preferred not to use them (as I think many others have) and did a direct connection at the rudder as shown in the attached photo.
Congratulations on getting your kit, way down in Ecuador. NOW the fun begins!

kit #95

mine too

PostPosted: Wed Aug 22, 2007 7:13 pm
by scubarider
yep, my attach brackets for the jury struts were also missing and not even on the packing slip.  They sent them too me when I found they were missing.  I did not use my rudder adjusts either.  Direct attach.
Congrats on the kit   :D

PostPosted: Wed Aug 22, 2007 8:04 pm
by Uwe Jens
Thank you very much for the info.  I hope my Highlander project gives as many satisfactions as it seems it gave to all you.  It is alredy giving me a lot of satisfaction by meeting new good people.  Thanks again for all the help you can provide me in the future and I hope I can do it too.
Best Regards,
Uwe/. :)