Wing ribs

Moderator: flying2nc

Wing ribs

Postby flying2nc » Sat May 18, 2013 11:48 am

To Make my cap strip pre bender I laid a piece of wax paper over the rib print {before I drilled any holes} traced it and cut it out then taped it to my remaining board halve and drew it on with a pencil,then went to about the wing CG and started there to put more bend in the airfoil as I went fore and aft, by the time I got to the leading edge I had about an 1" more curve to allow for springback and only had about 3/4" of an inch more at the trailing edge because there isn't as much curve or it's a gentler curve in the airfoil going aft.
I decided to use 1/4" cold rolled steel for my locator pins on the rib jig because the rib jig would never be exposed to the weather so the pins shouldn't rust. also the tolerances are close .003" close enough for what I am doing ALSO a 12 foot length at my local metal shop was only $7 + tax. I cut them into 2" lengths and knocked the edge off with a soft grinding wheel. Then drilled the rib jig board for where I wanted the locator pins. I thought I had done a good job in the placement of the pins leaving enough room to work around the vertical web pin locators but when gluing up my first rib found more room was needed to keep the epoxy from kicking around the pins on the top and bottom inside pins.!
After the epoxy kicked on the first rib, I had some one help me while I held the jig & spruce rib firmly,, and had them drive the pins out from the back! it didn't hurt the rib but there was a "click" when the epoxy broke loose from the pins,,,I re drilled the inside vertical web locator pins and moved them "inboard" approx, 3/4 to 1 inch, then glued 1/4" poplar wooden dowels in the old holes and lightly sanded them smooth . ( if your not making mistakes your not trying new things!)
Next rib came out great even used the same piece of wax paper.. "a little note" after trying a couple methods of putting wax paper on over the pins ,, I tried marking them with a marker and using a hole punch then tried planecrazzzy's method of burning them with a soldering iron over the pins but found the easiest for me was that if I flipped the jig over and weighted the wax paper with paper weights on the jig I had enough hole left over in the bottom to just stick the soldering iron in the hole threw the wax paper move it around a little ,perfect hole perfect fit.
Attachments
My Daughter  came over to help build plane here grinding and fitting wing rib webs.jpg
My Daughter the student pilot melting the wax paper for the wing rib jig locating pins.jpg
rib jig vertical web locator pin after I moved the locator pin closer to the center line.jpg
cap strip pre bender.jpg
User avatar
flying2nc
New Member
 
Posts: 4
Joined: Wed May 08, 2013 1:07 pm

Return to Tony's Buttercup Project