AT/50A and AR850 install in a homebuilt

Use this forum for in-depth discussion of avionics. radio, and GPS performance, design, options, and installation.

AT/50A and AR850 install in a homebuilt

Postby rocbar » Fri Jan 28, 2011 10:46 am

I am installing an older Narco AT50A transponder with a Narco AR850 encoder. I have all the manuals and everything is clear except.... Pin 18 of the transponder shows a wire going to "digitizer power" (maybe backup power?). However the encoder clearly says that power should originate from the avionics bus and not switched power from the transponder. The specific diagrams that show the hookup between theses 2 units does not show the pin 18 connection.
Question...What do I do ,or not do , with that old pin 18 red wire? Anyone familiar with this installation?
Thanks
rocbar
New Member
 
Posts: 1
Joined: Fri Jan 28, 2011 9:01 am

Return to Avionics, Flight Instruments & EFIS