Wing work

For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.

Moderator: scubarider2

Wing work

Postby KevinC » Tue Feb 19, 2008 10:39 am

Finally starting to cover the wings and a couple of questions came to mind:

How did everyone mark out/line up/drill the rivet holes for the rivet stitching?  make a jig? snap a chalk line? inboard or outboard side of the rib web?

how did you handle the fabric over the fuel tank area?  glued solid? strips? not at all?

thanks

K
User avatar
KevinC
Veteran Member
 
Posts: 436
Joined: Fri Aug 19, 2005 12:42 am
Location: Prosser, Washington

Postby DaveU » Tue Feb 19, 2008 12:08 pm

Kevin,
I marked and drilled the wing ribs before covering.  I put the rivets on the butt rib all the way out, except no rivets on the end rib that the wingtip attaches to.

I scribed a line on the side of the rib that did not interfere with the tanks or other items and then marked the spacing on the end ribs and snapped lines across the rest of the ribs.

I covered the wing and then melted the holes with a soldering iron, wiping the iron with a rag after every couple of holes.  

I brushed a coat on the entire top of the fuel tank, none on the bottom.  I then covered and shrunk the fabric then wiped the contact areas on the tank with MEK to stick it down.

Hope that helps.

Dave
DaveU
Veteran Member
 
Posts: 184
Joined: Thu Aug 17, 2006 12:20 am

yep

Postby scubarider2 » Tue Feb 19, 2008 1:40 pm

Yep, did exactly what Dave did.  Except I did NOT cover the whole tank with glue.  Just the edges.  Then shrunk the fabric tight.  I went outboard side of all ribs except the ends where the end tips go.  I would make sure that you drill the holes FIRST before putting on the fabric.  Burn them after.  Really layer the glue "lots" of coats is what Troy recommends especially on the bottom of the wings.  Use your small iron to get out ALL of the wrinkles immediately.  You are not going to cover them with paint...I know!   :?   Double and Triple make sure you have everything done BEFORE covering the wings.  You can't get in there after.  Mount everything and test it FIRST.  {the wings were the hardest to me}
Good Luck!
Dennis
User avatar
scubarider2
Topic Moderator
 
Posts: 1067
Joined: Mon Jan 28, 2008 7:03 pm
Location: Cleveland, GA


Return to Just Aircraft

cron