Besides near the pitot/static probes (and AOA probe in my case) are there other places that need an inspection hole reinforcement ring on the wings?
thanks
K
Wing inspection holes
- KevinC
- Veteran Member
- Posts: 447
- Joined: Fri Aug 19, 2005 12:42 am
- Location: Prosser, Washington
-
- Veteran Member
- Posts: 922
- Joined: Wed Mar 14, 2007 11:29 pm
- Location: Seattle WA
Re: Wing inspection holes
Is your AOA probe and system completely separate from your pitot/static system? If so, how far apart are the probes? Also, I don't see why JA runs the static line all the way along the pitot line. Why not come out the side of the fuselage like so many other airplanes do?KevinC wrote:Besides near the pitot/static probes (and AOA probe in my case) are there other places that need an inspection hole reinforcement ring on the wings?
thanks
K
Can you get to your 4 wing pulleys well enough without an inspection plate on each?
- scubarider2
- Topic Moderator
- Posts: 1086
- Joined: Mon Jan 28, 2008 7:03 pm
- Location: Cleveland, GA
inspection plate
The only inspection plate I put on the wings was for the pitot placement. I can get to each of pulley with the hole already cut. I did put a ring on each of the gas cap holes though.
Dennis
Dennis