FoldaPlane

For the technical discussion of aircraft airframe construction to include tips, techniques, questions, and recommendations.

FoldaPlane

Postby Sean_Caranna » Tue Sep 07, 2004 12:26 pm

The Corvair Personal Cruiser aircraft uses a concept called "FoldaPlane" where parts are shipped as flat composite panels and bonded together.

Image

This should alow for much lower shipping cost for aircraft kits due to the reduced physical size. I'm still trying to find out more about this but it sure looks like a good idea. I found the info on this at http://corvaircruiser.com/Cruiser/FAP.htm
"I'll have what the gentleman on the floor is having."
User avatar
Sean_Caranna
Owner
 
Posts: 231
Joined: Thu Aug 12, 2004 12:34 am
Location: Daytona Beach, FL

Postby Dvoit » Sat Sep 11, 2004 7:38 pm

I am building one of the beta versions of the Corvair Cruiser. The prototype is getting close to flying except it is located in Datona Beach, Florida and the hurricanes have made a mess of the schedule but not the plane. My project is just at the point of finishing the tail and within a week I will be working on the control rods and then on to landing gear. It should be the second one to fly but that is at least a year off, maybe more. At this point I am delighted with the design and construction techniques. The foldaplane technique unloads a lot of the exterior finishing work since the majority of the fuselage external surfaces are already made by vacuum baggin and thus are light and smooth. It takes a little planning and sorting out to do the final folding of the fuselage but I got it sorted out in a few hours. The airfoil surfaces will need the normal hand smoothing but at least a lot of work is avoided. The prototype is coming in very light and I hope I can say the same but it is my first plane and I don't know enough to compare.

You can see a somewhat old photo of me in the builder section of the cruiser web site.
Dvoit
New Member
 
Posts: 1
Joined: Tue Aug 31, 2004 6:20 pm
Location: Lodi, California

Postby mikessynoil » Sat Jan 23, 2010 9:41 pm

mikessynoil
New Member
 
Posts: 3
Joined: Tue Jun 10, 2008 4:49 pm
Location: Tampa Bay, Florida


Return to Airframe Construction

cron