Ok - this is a DUMB question and I apologize in advance - perhaps I am going blonde.
The manual [!!] says to level the headrack side to side and front to back and then set the elevator to 0 deg relative to the headrack (for Rotax). I have one of those super-whamadyne Smart level tools that measures the angle to 0.1 degree and don't really want to take the a/c off the 'rotisserie' that I have it mounted on to shim it up to level front to back. Is there any reason I can't just measure the angle of the headrack and duplicate it with the elevator (hence 0 degrees)? Am I missing something? It's an important hole to drill....
k
setting the elevator
- KevinC
- Veteran Member
- Posts: 447
- Joined: Fri Aug 19, 2005 12:42 am
- Location: Prosser, Washington