Paint on drag tubes

For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.

Moderator: scubarider2

Paint on drag tubes

Postby Bay State Flatlander » Sun Jan 25, 2015 11:23 am

I was preparing the spar and drag tubes for hysoling the gussets in place. After sanding with 320 grit to "key" the surfaces I wiped down the areas with Acetone. Much to my surprise , what I thought was gray powder coat wiped off with the Acetone. There is white underneath which I am assuming is powder coat. I figured I scuffed the area enough so the hysol has a mechanical grip so I went ahead and glued in the gussets on one wing. Any thoughts on this?

Highlander kit 331
After sanding and acetone wipe
Bay State Flatlander
Forum Regular
Posts: 20
Joined: Tue Jan 21, 2014 12:18 am
Location: Central Massachusetts

Re: Paint on drag tubes

Postby danerazz » Sun Jan 25, 2015 4:27 pm

I have the factory "quick-build" wings and they do not have any paint over the powder coat on the drag tubes. If it is powder coating under the paint, the. Yes, just a good scuffing and alcohol/acetone wipe and bond them in. The factory did not remove the powder coat prior to gluing the gussets in. I had to remove a gusset to fix some shipping damage and it took a lot of heat to get the hysol to let go. I then cleaned the area and just glued the gusset back in place, rock solid.

Paralysis by analysis
Veteran Member
Posts: 937
Joined: Tue Aug 18, 2009 9:33 pm
Location: Bangor

Return to Just Aircraft