Rudder Pedal Free Movement

For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.

Moderator: scubarider2

Rudder Pedal Free Movement

Postby sonex293 » Tue Sep 01, 2015 9:31 am

Ok, my build partner and I have made it to the rudder pedal installation phase. The builder's manual indicates some "massaging" will be need to get the pedals to move freely. What have others done to "message" the assembly for better/free-er movement? I've got over 5 hours into "massaging" these things and I still not sure how freely they need to move. The shims can also compress a little, so it's hard to check things without torquing the bolts down, just to find that it binds on one of the four attach points. ARGH. Very Very Frustrating.

Anyone have a sure fire system for getting the pedals installed with free movement?

Building Highlander #371
User avatar
Veteran Member
Posts: 115
Joined: Sat Aug 28, 2004 9:18 am
Location: Cary, NC

Re: Rudder Pedal Free Movement

Postby SheepdogRD » Tue Sep 01, 2015 9:36 am

I fought with that until I measured the relative height of the mounts. The outside right mount was welded 0.040" lower than the others. Once I got that shimmed, the assembly moved smoothly.
Richard Holtz
Highlander N7340Z -- Ms. Tonka -- in gestation

If just enough is really good, then too much ought to be perfect.
User avatar
Veteran Member
Posts: 696
Joined: Tue Nov 30, 2010 5:41 pm
Location: West of Atlanta, GA

Re: Rudder Pedal Free Movement

Postby smiley » Tue Sep 01, 2015 7:26 pm

I found the same problem as sheepdog. I used non-locking nuts and worked with the shims and then they work nicely.
Massaging is not a good term for this, More like tedious
Forum Regular
Posts: 25
Joined: Sun May 05, 2013 6:12 pm

Re: Rudder Pedal Free Movement

Postby taildrgfun » Thu Sep 03, 2015 9:59 am

I leave all the bolts slightly loose so that everything can have a little tiny bit of free play and it really helps.
Steve Henry, Wild West Aircraft
(the Dead Stick Take-off Guy)
Veteran Member
Posts: 454
Joined: Sat May 17, 2008 12:34 am
Location: Nampa Idaho

Return to Just Aircraft