Can anyone enlighten me on the instructions for the elevator trim. There are no directions for mounting the plates etc. I have lots of parts but can't figure out how to use them. I have plates for mounting but have several. Are there different locations? I do have some pictures for the mounting next to the flaps handle but just not sure. Any help would be much appreciated.
Thanks!
Elevator trim help
-
- Veteran Member
- Posts: 287
- Joined: Sun Dec 24, 2006 10:06 am
- Location: Cleveland, GA
Elevator trim help
Living life on the edge makes me dizzy. I love Dizzy!
- KevinC
- Veteran Member
- Posts: 447
- Joined: Fri Aug 19, 2005 12:42 am
- Location: Prosser, Washington
-
- Veteran Member
- Posts: 287
- Joined: Sun Dec 24, 2006 10:06 am
- Location: Cleveland, GA
thanks
Thanks Kevin, you have been a great help to me. I received three plates labled trim elevator. Three different sizes. Does one go on the elvelator itself? Any words of wisdom on how to mount it? How far forward etc.? What angle? Does it matter?
Thanks again!
Great pictures!!!
Thanks again!
Great pictures!!!
Living life on the edge makes me dizzy. I love Dizzy!
-
- Forum Regular
- Posts: 25
- Joined: Thu Nov 03, 2005 6:23 pm
- Location: Eleva, WI
- Contact:
My web page about how I put the trim together is located at: http://www.tcc.coop/~tpadams/_sgg/m2m3s1_1.htm
I'm also attaching some pic's took of one Cornell Aero Works was constructing - that's how I figured out how to do mine.
I'm also attaching some pic's took of one Cornell Aero Works was constructing - that's how I figured out how to do mine.
Tim
-
- Veteran Member
- Posts: 287
- Joined: Sun Dec 24, 2006 10:06 am
- Location: Cleveland, GA
fantastic
Fantastic!...Thanks so much. Pictures are great. Now if I had all the parts I could get it done!.. :(
Dennis
Dennis
Living life on the edge makes me dizzy. I love Dizzy!