Well, I'm finally getting around to sticking some fabric on this airplane. I am starting with the bottom piece on the reccomendation of a bunch of folks, and I had a situation with the fabric at the fwd main gear hard point that I didn't like. Namely, what to glue the fabric to. So I charged off into building fabric plates for the hard points. See photo.
Wes
Kit #95
Fabric Covering Stuff
- Wes
- Premium Member
- Posts: 231
- Joined: Mon Jan 23, 2006 10:32 pm
- Location: Satellite Bch, Florida
Fabric Covering Stuff
You do not have the required permissions to view the files attached to this post.
Kit # 95
Low and Slow - The only way to go!
Low and Slow - The only way to go!
-
- Veteran Member
- Posts: 287
- Joined: Sun Dec 24, 2006 10:06 am
- Location: Cleveland, GA
nice job
Nice job. All I did was glue to the tube along with the inside of where you mount the wheel legs. I then reinforced with tape.
D
D
Living life on the edge makes me dizzy. I love Dizzy!
- Wes
- Premium Member
- Posts: 231
- Joined: Mon Jan 23, 2006 10:32 pm
- Location: Satellite Bch, Florida
Fabric Plates on fuselage
Dennis,
Thanks for the reply. Saw some pics of this area that just left a hole on the fwd side (see attached) and I thought that may be a place for mud to get in (since I dont plan on landing on any paved runways).
Looks like you are making good progress on your kit.
Wes
Thanks for the reply. Saw some pics of this area that just left a hole on the fwd side (see attached) and I thought that may be a place for mud to get in (since I dont plan on landing on any paved runways).
Looks like you are making good progress on your kit.
Wes
You do not have the required permissions to view the files attached to this post.
Kit # 95
Low and Slow - The only way to go!
Low and Slow - The only way to go!