I know this has been coverred extensively Im sure. But i thought i'd make a contribution for the guy who is new to all of this like me.
I saw a video of someone using a large caulk gun and 2 dowels to make a dispenser. I did the same but with 1"pvc run through a table saw to give it the perfect id.
I also read about using pastry bags so i bought these on Amazon. Thin but strong One,two,or three squirts, then i roll it down with a socket, twist, tie, mix, snip the end and go.
Allows for much cleaner application.
Using hysol
-
- Seasoned Member
- Posts: 63
- Joined: Tue Sep 18, 2018 9:15 pm
Using hysol
You do not have the required permissions to view the files attached to this post.
Ed Whitaker
Humble Novice
What do you get when things don't go as planned? Experience.
Humble Novice
What do you get when things don't go as planned? Experience.
- danerazz
- Veteran Member
- Posts: 1245
- Joined: Tue Aug 18, 2009 9:33 pm
- Location: Bangor
Re: Using hysol
I use this https://www.amazon.com/CNBTR-Dispenser- ... EK3PWXXK9S
With corresponding mixing tubes.
https://www.amazon.com/3M-38191-Static- ... RGT9Z1TQFH
It is less than $15 for the gun, mixing tubes are cheap. They sell the hysol tubes as well (about $15), and I only have to mix what I need instead of a bunch of waste. If I only need a little, I just squirt some on a scrap of aluminum or paper plate and mix by hand. If I need a bunch I use the mixing tubes due to the inherent waste.
With corresponding mixing tubes.
https://www.amazon.com/3M-38191-Static- ... RGT9Z1TQFH
It is less than $15 for the gun, mixing tubes are cheap. They sell the hysol tubes as well (about $15), and I only have to mix what I need instead of a bunch of waste. If I only need a little, I just squirt some on a scrap of aluminum or paper plate and mix by hand. If I need a bunch I use the mixing tubes due to the inherent waste.
Dane
Paralysis by analysis
#242
Paralysis by analysis
#242
- BucF16
- Veteran Member
- Posts: 463
- Joined: Sun Mar 23, 2014 11:47 am
- Location: Alexandria, Ohio
Re: Using hysol
Remember, if you are going to use/need these mixer/applicators, save a lot of projects and do them all at once. A lot Of Hysol gets wasted in the mixer. I bought this applicator on Ebay when someone on another thread discussed it. It uses the 200 ml cartridges.
Good Luck!
Bruce
You do not have the required permissions to view the files attached to this post.
Bruce Johnson Highlander # 393
"Because I fly, I envy no man on Earth"
Builder web site:
http://www.bruceshighlander.blogspot.com
"Because I fly, I envy no man on Earth"
Builder web site:
http://www.bruceshighlander.blogspot.com