Carbon Fibre Propellers:
What are accepted procedures for the repair of Carbon Fibre propellers ? In particular mine is an Arplast from France but cannot obtain any help from the manufacturer. Prop is all carbon with no metal leading edge. At present there are stone nicks which should be dressed. The nicks are all small with the largest being about 1/4 inch wide.
This is a three blade on a Rotax 912 ULS Any info on maintenance and repair would be appreciated .
Thanks Milt K
Carbon Fibre Propeller Maintenance
-
- New Member
- Posts: 3
- Joined: Thu May 03, 2007 8:57 pm
- Location: SW Wisconsin
- meglin
- Veteran Member
- Posts: 103
- Joined: Sun Aug 16, 2015 9:22 am
- Location: Ukraine
- Contact:
Re: Carbon Fibre Propeller Maintenance
This repair is preferable to make the producer himself.
He has specific materials that he used earlier, accessories for the manufacture of the blades.
If not damaged blade spar, the problems with the repair should not be.
We always took the blade repair. But if the spar is damaged, it is safer just to replace the blade.
The manufacturer has a database with accurate data generated by each blade.
There is no problem to make an exact copy, and send you.
Best regards
Vladimir Meglinsky
My site: http://propeller.simplesite.com
He has specific materials that he used earlier, accessories for the manufacture of the blades.
If not damaged blade spar, the problems with the repair should not be.
We always took the blade repair. But if the spar is damaged, it is safer just to replace the blade.
The manufacturer has a database with accurate data generated by each blade.
There is no problem to make an exact copy, and send you.
Best regards
Vladimir Meglinsky
My site: http://propeller.simplesite.com
- meglin
- Veteran Member
- Posts: 103
- Joined: Sun Aug 16, 2015 9:22 am
- Location: Ukraine
- Contact:
Re: Carbon Fibre Propeller Maintenance
foto
You do not have the required permissions to view the files attached to this post.
- meglin
- Veteran Member
- Posts: 103
- Joined: Sun Aug 16, 2015 9:22 am
- Location: Ukraine
- Contact:
Re: Carbon Fibre Propeller Maintenance
Our propellers on airplanes RV, Savage and Savannah.
You do not have the required permissions to view the files attached to this post.
- meglin
- Veteran Member
- Posts: 103
- Joined: Sun Aug 16, 2015 9:22 am
- Location: Ukraine
- Contact:
Re: Carbon Fibre Propeller Maintenance
our carbon propellers are on different planes.
You do not have the required permissions to view the files attached to this post.
- meglin
- Veteran Member
- Posts: 103
- Joined: Sun Aug 16, 2015 9:22 am
- Location: Ukraine
- Contact:
Re: Carbon Fibre Propeller Maintenance
The ideal propeller for Rotax-503 is 2.58. The propeller thrust is 159 kgf.
You do not have the required permissions to view the files attached to this post.